2008 ford explorer owners manual for air conditioner. Air Conditioning & Heater Parts for 2008 Ford Explorer 2019-03-25

2008 ford explorer owners manual for air conditioner Rating: 7,6/10 1093 reviews

2008 Ford Explorer Air Conditioning System

2008 ford explorer owners manual for air conditioner

Note: In the illustrations, lightning bolts are used to designate the assisting boosting battery. Remove the old bulb by turning counterclockwise and pull it out. Ford says trailing arms added to the rear suspension in 2006 make it more robust. Later in the model year, in place of a standard fuel cap Ford will introduce a cap-less fuel filler. If the indicators stay on or flash faster, check for a burned out bulb.

Next

Ford Explorer Workshop & Owners Manual

2008 ford explorer owners manual for air conditioner

Doing so will produce excessive noise, increase tire wear and may damage drive components. Exterior Eddie Bauer and Limited models offer power running boards. The Explorer competes with the Chevrolet TrailBlazer, Jeep Grand Cherokee and Nissan Pathfinder. Turn signal: Illuminates when the left or right turn signal or the hazard lights are turned on. Mixing Motorcraft Specialty Orange Engine. Fill the fuel tank completely and record the initial odometer reading in miles or kilometers. Never place your hand between the extended running board and the vehicle.

Next

2008 Ford Explorer Air Conditioning System

2008 ford explorer owners manual for air conditioner

Check for holes or cuts that may permit air leakage from the tire and make necessary repairs. Frontal airbags are not designed to inflate in rear and side crashes or rollovers. See your authorized dealer for more information on tire cables for your vehicle. Engine oil filler cap 3. Make sure the tongue is securely fastened in the buckle. Position the safety belt comfort guide so that the belt rests across the middle of your shoulder.

Next

FORD EXPLORER 2008 OWNER'S MANUAL Pdf Download.

2008 ford explorer owners manual for air conditioner

Press the rear defroster control to clear the rear window of thin ice and fog. Repair the damaged road wheel and re-mount it on the vehicle to restore system functionality. High beams: Illuminates when the high beam headlamps are turned on. How to disengage the automatic locking mode Unbuckle the combination lap and shoulder belt and allow it to retract completely to disengage the automatic locking mode and activate the vehicle sensitive mode. Brake fluid level low Check headlamp Check highbeam lamp. Remove the bulb socket from the lamp assembly by turning counterclockwise and pull the bulb straight out.

Next

2008 Ford Explorer A/C Compressor

2008 ford explorer owners manual for air conditioner

If the procedure needs to be repeated, you must wait 30 seconds. In general, tires should be replaced after six years regardless of tread wear. Ford says the system saves refueling time and can provide a better seal to trap fuel vapors. What is included in Roadside Assistance? Turn the blade at an angle from the wiper arm. If the air bag has deployed, the air bag will not function again and must be replaced immediately. If all remote entry transmitters are not present during the programming procedure, the transmitters that are not present during programming will no longer operate the vehicle. In extreme climates, excessive ice buildup may occur, causing the running boards not to deploy.

Next

Ford Explorer Questions

2008 ford explorer owners manual for air conditioner

A chrome four-bar grille, unique bumpers, fog lamps, puddle lamps and 16-inch al. Selectable languages are English, Spanish, French, Japanese, or Arabic. If the fuel filler cap is venting vapor or if you hear a hissing sound, wait until it stops before completely removing the fuel filler cap. For example, the numbers 317 mean the 31st week of 1997. If a disc is present, it will resume or begin to play.

Next

2008 Ford Explorer Expert Reviews, Specs and Photos

2008 ford explorer owners manual for air conditioner

Call your local authorized recycling center to find out more about recycling automotive batteries. This mode should be used any time a child safety seat, except a booster, is installed in passenger front or rear seating positions. Press one side of the control to adjust firmness. If you and your friend each weigh 220 lb. Check with your authorized dealer for availability. Even though the passenger airbag is disabled, the pass airbag off lamp may or may not be illuminated according to the table below. When towing, trailer tongue load or king pin weight is also part of cargo weight.

Next

Ford Explorer Workshop & Owners Manual

2008 ford explorer owners manual for air conditioner

Routine maintenance of the airbag is not required. Allow the belt to retract. Navigation-equipped Explorers now use voice-activation. The user should receive a horn chirp to indicate the system has been disabled or a chirp followed by a honk to indicate the system has been enabled. Ford strongly recommends that drivers use extreme caution when using any device that may take their focus off the road.

Next

2008 Ford Explorer Expert Reviews, Specs and Photos

2008 ford explorer owners manual for air conditioner

The pressure in an overfilled tank may cause leakage and lead to fuel spray and fire. In case of acid contact with skin or eyes, flush immediately with water for a minimum of 15 minutes and get prompt medical attention. If the air bag is not replaced, the unrepaired area will increase the risk of injury in a collision. Rotate the bulb socket counterclockwise and remove it from the lamp assembly. Route the tether strap under the head restraint and between the head restraint posts.

Next

2008 Ford Explorer Air Conditioning System

2008 ford explorer owners manual for air conditioner

Refer to the Maintenance and Specifications chapter for the lubricant specification. Note: To change oil life 100% miles value from 7,500 miles 12,070 km or 6 months to another value, proceed to step 3. Operation is subject to the following two conditions: 1 This device may not cause harmful interference, and 2 This device must accept any interference received, including interference that may cause undesired operation. It will not be capable of providing audio to the speakers. To calibrate, press and hold the reset button on the compass module for approximately eight seconds and release.

Next